Harbor Breeze E-YLM52WW5C1 Manual Del Usuario página 8

INITIAL INSTALLATION
7. Insert downrod (A) through canopy (B), canopy
cover (W) and yoke cover (E). NOTE: Canopy
cover (W) must be turned with the shiny side
toward the motor housing (D).
Then, thread wires from motor housing (D)
through downrod (A).
8.
Slip downrod (A) into motor housing yoke, align
holes and re-install pin (L) and clip (M). Tighten
set screws in motor housing yoke and then
tighten preassembled nuts on the set screws.
Then, slide yoke cover (E) down until it rests on
top of motor housing (D).
9. Depending on the length of downrod you use,
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested you do so in the
following manner:
Take the lead wires and make sure you have
pulled them all the way through the top of the
downrod. Start at the TOP of the hanging ball on
the downrod and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters (not
included).
NOTE: If you do not cut back the lead wires,
Steps 9 and 10 are not necessary and you
may proceed to Step 11 instead.
7
B
W
8
M
L
M
D
9
Lowes.com/harborbreeze
8
A
E
A
E
Set Screw
and Nut
L
Yoke
8 in.
Hanging
Ball
A