Surface Mounting
1
Installing the mounting brackets
□ Connect three of the mounting brackets from the
appropriately sized Surface Mounting Kit (BB or CC)
using the screws included in the kit.
□ Use a Phillips
screwdriver
(not included)
to tighten the
screws.
3
Connecting the electrical wires
□ Remove the driver cover to access the wiring and push connectors.
□ With help from another person, hold the LED flat panel (A) near the ceiling while
connecting the electrical wires.
□ Insert the live black wire from the electrical outlet box into the push connector
opening labeled "ACL" in the driver box on the back of the LED flat panel (A).
□ Insert the neutral white wire from the electrical outlet box into the push connector
opening labeled "ACN" in the driver box on the back of the LED flat panel (A).
□ Connect the ground wire from the electrical outlet box to the yellow wire in the driver
box on the back of the LED flat panel (A).
□ If a 0-10v dimming circuit is available, insert the purple wire from the electrical outlet
box into the push connector labeled "DIM+" and the gray wire from the electrical
outlet box into the push connector labeled "DIM-" in the driver box on the back of the
LED Flat Panel (A).
□ Replace the driver cover once wiring connections are complete, fully tightening the
screw to hold it securely in place.
CAUTION: Do not allow the DIM+/- and LED +/- wires to make contact as it will cause
damage to the LED Driver.
2
Attaching the mounting brackets to
the ceiling
□ With help from another person, hold the assembled
mounting brackets to the ceiling and use a pencil to mark
the locations of the mounting holes.
□ Drill four 1/4 in. diameter holes into the four screw
locations marked on the ceiling.
□ Insert a drywall anchor into each of the drilled holes.
□ Secure the
mounting
brackets tightly
to the ceiling
using four
screws inserted
into the drywall
anchors.
8
LED Driver