Troubleshooting Tips; Troubleshooting Table - sunjoe 24V-HCS-LTE Manual Del Operador

Guide Bar Maintenance
When the guide bar shows signs of wear, turn it over on the
saw to distribute the wear for maximum bar life. Feathering or
burring of the bar rails is a normal process of bar wear. You
should smooth such faults with a file as soon as they occur.
Replace a bar with any of the following faults:
• wear inside the bar rails permitting the chain to
lay over sideways
• bent guide bar
• cracked or broken rails
• spread rails
Turn the saw over, check the underside of the guide bar, and
make sure that the lubrication holes and chain groove are free
from impurities.
You can purchase replacement parts for your Sun Joe
24V-HCS-LTE cordless pruning saw by ordering online at
sunjoe.com or, to order by phone, contact Snow Joe
Sun Joe customer service at 1-866-SNOWJOE
®
(1-866-766-9563).
Chain Sprocket
Regularly check the condition of the sprocket and replace it
when wear exceeds 0.5 mm (Fig. 19).
Do not mount a new chain with a worn sprocket or vice-versa.
Fig. 19
Troubleshooting

Troubleshooting Tips

Most difficulties are easy to fix. Consult the troubleshooting
table for common problems and their solutions. If you continue
to experience problems or need repairs beyond these minor
adjustments, please call 1-866-SNOWJOE (1-866-766-9563)
for assistance.
m
WARNING!
Always remove the battery before
performing any adjustments, maintenance, or repairs to your
cordless pruning saw.
®
+
®
< 0.5 mm
17

Troubleshooting Table

Problems Corrective Action
The saw
•
Make sure that the battery is inserted correctly
motor fails
•
Check charge status and recharge the battery
to start
•
Make sure that the battery is inserted correctly
The saw
stops during
•
Check charge status and recharge the battery
operation
•
The machine is overloaded
The saw
runs, but
•
the chain
The chain is too tight; re-tension.
speed is
low
Bar and
•
The chain tension is too tight; re-tension.
chain
running
•
The chain need to be lubricated: lubricate the
hot and
chain with the oil.
smoking
The saw
motor
•
The chain tension is too tight; re-tension.
runs, but
•
The guide bar or chain is damaged; inspect
the chain
and replace the damaged part.
is not
turning
Daily Checklist, Cleaning
and Storage
Daily Checklist
To help maintain your cordless pruning saw for optimum
performance, we recommend you complete this checklist prior
to each work session.
m
WARNING!
Do not insert the battery until you have
completed all of the daily checks.
• Inspect for any visible damage to the chain, guide bar, or
motor housing.
• Inspect the guide bar rails and clean them to remove any
debris.
• Check the chain tension.
• Check the chain teeth for sharpness.
NOTE: If you notice anything unusual, such as a vibration or
odd sound, shut the saw OFF immediately. Remove the battery
and check the saw for any damage.
If you cannot find the cause of the problem or are uncertain
what to do, then have the saw inspected by an authorized
Snow Joe + Sun Joe dealer or call the Snow Joe
® ®
Sun Joe customer service center at 1-866-SNOWJOE
®
(1-866-766-9563) before using it.
+
®