Monti POWER MBX AXIAL Manual De Instrucciones página 6

EN Operating instructions
5. The compressed air supply
This pneumatic tool is designed for a maximum flow pressure of 75 psi (5.2 bar).
Correct air pressure increases the service life!
The compressed air supply must be free of water. For this reason, a water separator should be
used to prevent condensation. If the compressed air hose is too long, the tool will not be supplied
with the required air pressure. To ensure that the compressed air motor operates properly and
has a long service life, the use of a lubricator for the compressed air line is strongly recommended.
6. Putting into operation
Application area:
The axial design has advantages over conventional MBX
uses and applications. For example, work on flanged edges of doors and hoods, on ar roof joints
and wheel arches and other hard to reach places can be facilitated with the MBX
Handling:
6.1 The tool should always be equipped with the supplied protective hood. (See Fig. 1)
6.2 Connect the tool to a compressed air system with maintenance unit (filter, regulator, oiler).
6.3 When selecting an MBX
Belts are available:
• Use WITHOUT accelerator bar: MBX
steel coarse or fine.
• Use WITH accelerator bar (see Chapter 8, 9): Bristle Blaster
left.
6.4 Disconnect the compressed air supply and then properly attach the MBX
using the corresponding adaptor system and observe the running direction (See Fig. 2).
6.5 Start the tool by moving the safety stop forward and pressing the safety stop forward and
press the start lever. The start lever will return to its original position when released.
6.6 Continuous speed control: The MBX
pressure on the valve lever. Light pressure results in a low speed, making a smooth,
controlled start-up possible. This allows the most suitable speed to be selected for the
work to be performed.
6.7 Prevent water (moist air) from entering the pneumatic tool under all circumstances.
6
®
Belt, consider the surface that will be machined. The following
®
coarse, MBX
®
Axial tool runs at variable speed depending on
®
in-line tools in many areas for many
® ®
medium, MBX fine, MBX
®
Belt 11 mm, 11 mm right, 11 mm
®
MBX AXIAL
®
Axial.
®
stainless
®
Belt to the tool