Descargar Imprimir esta página

Scubapro Galileo HUD Manual De Instrucciones página 3

Ocultar thumbs Ver también para Galileo HUD:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 22
Standard EN 250:2014. The full text of the EU declaration of conformity is available
at www.scubapro.eu/declarations-conformity.
Depth Rating
Before diving with your new SCUBAPRO dive computer, please refer to the
INTRODUCTION or TECHNICAL INFORMATION sections of your dive computer
user's manual to learn about the specific maximum operating depth and
decompression calculation range.
Diving at oxygen partial pressures higher than 1.6bar (corresponding to a depth
of 67m/220ft when breathing compressed air) is extremely dangerous and could
lead to serious injury or death.
Wake Up Your Computer First
You must turn on computer manually prior to first dive.
The computer comes from the factory in a special hibernation mode that
preserves the battery. Starting the dive without turning on the computer manually
may result in the computer not functioning throughout the dive.
Perform Safety Stop
Even when performing a PDI stop, you still MUST perform a safety stop at
5m/15ft for 3 to 5 minutes. Performing a 3 to 5 minute stop at 5m/15ft at the end
of any dive is still highly recomended by recognized training agencies!
If Your Dive Computer Has A User Replaceable Battery Please Note The
Guidelines Below And Follow The Procedures As Outlined In The User
Manual.
We recommend having the battery of your SCUBAPRO dive computer replaced
by an authorized SCUBAPRO dealer. The change must be made with particular
care in order to prevent water from seeping in. The warranty does not cover
damages due to an improper replacement of the battery.
• A leaking battery cap may lead to the destruction of your SCUBAPRO dive
computer by water seeping in or causing it to switch off without prior notice.
• Always open the battery compartment in a dry and clean environment.
• Only open the battery compartment to replace the battery.
• Never touch the metal surface of the battery with bare fingers. The two
battery poles must never be short circuited.
Charging The Battery Of Your SCUBAPRO Dive Computer
• Charge only with the supplied cable.
• Dry the instrument and connector before charging. Charge only in a dry room.
• Do not open a rechargeable instrument.
! Read First ! ! Read First ! ! Read First ! ! Read First !
! Read First !
3

Publicidad

loading