Sordin SHARP Manual De Instrucciones página 5

• This hearing protector is provided with level-dependent attenuation. The wearer should check correct
operation before use. If distortion or failure is detected, the wearer should refer to the manufacturers
advice for maintenance and replacement of the battery.
• Performance may deteriorate with battery usage. The typical period of continuous use that can be
expected from the hearing protector battery varies depending on the mode of use and volume output.
The typical period of continuous use in ambient mode with mid-volume is 36 hours.
• The output level-dependent circuit of this hearing protector may exceed the external sound level.
• This hearing protector is provided with an entertainment audio facility. The entertainment (FM Radio
and Bluetooth streaming) audio signal sound pressure level is limited to 82dB(A) effective to the ear.
• The audibility of warning signals at a specific workplace may be impaired while using the entertainment
facility.
• This product may be adversely affected by certain chemical substances. Further information should be
sought from the manufacturer.
• Clean the product regularly. Use a cloth with water and soap. Do not wash or put fully into water.
• Hearing protectors, and in particular cushions, may deteriorate with use and should be examined at
frequent intervals for cracking and leakage, for example.
• The fitting of hygiene covers to the cushions, may affect the acoustic performance of the hearing
protectors.
• The product contains battery and electrical components that may cause ignition in flammable or
explosive atmospheres. Do not use in environments where sparks may cause a fire or explosion.
• Do not put the product in storage at temperatures above +55°C and below -20°C.
• Only use the product between temperatures -20°C and +55°C.
• Only charge the product between temperatures 0°C and +40°C.
• Ensure that the product is not damaged during transportation and use.
• Do not press the earmuffs against the helmet shell as this can cause cracks around the side of the
helmet.
• Do not change or remove parts on the product. Only do changes that are given in this manual. All
service and repair work must be done by an approved service workshop.
• Make sure that the charger cable and charger used, fulfill country specific regulations. Do not leave the
hearing protector to charge unattended.
• Only use Sordin original spare parts.
• Never use the earmuffs longer than 10 years from the manufacturing date stated on the packaging.
• Dispose the product in accordance with national legislation.
OPERATION
Introduction
WARNING!
Before you operate the product, you must read and understand the safety chapter.
Before following the fitting instructions, move your hair aside and remove any objects that could affect
acoustic seal. Make sure that the sealing rings are tight around your ears before you operate the product.
To put the hearing protectors in operating position (Sordin SHARP-1): Place the cups over the ears and
adjust the headband and cups until they are in a comfortable position. Adjust the earmuffs until they are
tight around your ears and tight against your head. (Fig.2)
To assemble the hearing protectors to a helmet (Sordin SHARP-2): Lift the earmuffs out and up until
they lock in standby position. (Fig.3). Put the helmet attachment in the slot on the helmet. (Fig.4)
For further tips on cable routing, visit www.sordin.com; search for SHARP.
To put the hearing protectors in operating position (Sordin SHARP-2): Put the helmet on your head.
Adjust the earmuffs until they are tight around your ears and tight against your head. (Fig.5)
5