Kit Assembly - Metra 95-6533B Instrucciones De Instalación

ISO DDIN radio provision
1. The top of the radio opening in
each application will need cut or
filed to make room for the new
DDIN radio. Temporarily attach the
provided cutting template to the
back of the dash panel using the
locating pins and/or snaps to align
it correctly. Mark the factory panel
for cutting, remove the template,
and cut and file accordingly.
(Figure A)
2. Snap the radio trim panel over the
front of the factory radio panel (the
snaps will be at the top of the radio
opening). (Figure B)
3. Secure the radio trim panel
retainers to the radio trim panel
using the #8 x 3/8" screws
included with the kit.

Kit Assembly

Remove shaded area
Cutting template
(Figure A)
Jeep Grand Cherokee shown here
(Figure B)
95-6533B
4. Attach the radio brackets to the
radio using the screws supplied
with the radio. (Figure C)
5. Locate the factory wiring harness
and antenna plug in the dash and
make all necessary connections
to the radio. Metra recommends
using the proper mating adapter
from Metra or AXXESS. Re-connect
the negative battery terminal and
test the radio for proper operation.
6. Reassemble the dash in reverse
order of disassembly.
3
(Figure C)