Mopar 82215227 Instrucciones De Instalación página 5

Cobertor plegable duro para tolva de camioneta
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. RAIL CLAMP INSTALLATION- Standard bed
Place the clamps (5) starting at the
3.2
front, approximately 6 to 10 inches or
152 to 254 mm from the bulkhead.
Hand tighten to hold the clamp in place.
3.3
Place the rear (tailgate) clamp (6) at the
end of the rail approximately 6 inches
or 152 mm from the tailgate. Hand
tighten to keep in place.
Place the second/middle clamp (7) near
3.4
the center of the rail. Hand tighten to
keep in place.
3.5
Starting with the front clamp,
make sure the rail is pushed forward
against the bulkhead, and square with
the bed rail, apply downward pressure
on the rail while tightening the bolt.
Repeat with the middle and rear
clamps, making sure the rail is
square with the bed rail.
3.6
Repeat for the opposite rail.
Proceed to Step 5
June 20, 2019
www.mopar.com
Front / Cab
Front / Cab
6
Rear/Tailgate
10 ft/lbs
10 pi*lb
10 lb-pie
13,6 N-m
5
5
7
K6862677

Publicidad

Tabla de contenido
loading

Tabla de contenido