Transportation And Storage; Before Calling For Service - Redmond RMC-M90E Manual De Usuario

The side walls of the working chamber, the surface of the heating disc and the housing of the central temperature sensor
(located in the middle of the heating disc) can be cleaned with moistened (not wet!) sponge or cloth. If you use detergent,
you should carefully remove the residue to avoid the appearance of unwanted odor during subsequent cooking.
If foreign objects get into the recess around the central temperature sensor, carefully remove them with tweezers, without
pressing on the sensor housing.
If the surface of the heating disc is dirty, it is allowed to use a moistened medium-hardness sponge or a synthetic brush.
With regular use of the device over time, the color of the heating disc can completely or partially change. This is not a sign of
malfunction and does not affect the correct operation of the device.

Transportation and Storage

Before repeated operation or storage completely dry all parts of the appliance. Store the assembled appliance in a dry,
ventilated place away from heating appliances and direct sunlight.
During transportation and storage, do not expose the device to mechanical stress, that may lead to damage of the device
and/or violation of the package integrity.
Keep the device package away from water and other liquids.
VII. BEFORE CALLING FOR SERVICE
Problem Possible cause
Display shows the error
System error; system board or heating element malfunction.
code: Е1–Е4
Display shows the error
The automatic overheating protection was triggered
code: Е5–Е7
Power cord is not connected to the appliance and/or
socket
The device does not
switch on. Wall socket is not working properly
Power supply failure
Dish is taking too long to Power supply interruption (power supply is unstable/under-
cook rated)
There is a foreign object between the bowl and the heating
element (grain, food particles, debris, etc.)
Dish is taking too long to
The bowl is not properly positioned
cook
Heating disk is dirty
Problem
Hot steam escapes from
under lid during cooking.
The count of program run-
ning time starts
In case you didn't manage to eliminate the defects, please, refer to the authorized service centre.
ity centre. With this little extra effort, you can help to ensure that valuable raw materials are recycled and pollutants are treated
as appropriate.
Solving the problem
This appliance is labelled in accordance with European Directive 2012/19/EU — concerning used electrical and electronic
Unplug the unit and let it cool down. Close the
appliances (waste electrical and electronic equipment WEEE).
lid tightly. Switch the unit back on. If this does
The guideline determines the framework for the return and recycling of used appliances as applicable throughout the EU.
not eliminate the error, address an authorized
service center
Do not start cooking with an empty bowl!
Disconnect the appliance from the mains, open
the lid and let it cool for 10-15 minutes, then
continue cooking
Do not add water to the bowl during operation
of MULTI COOK (when the temperature is set
above 100 °C) and FRY programs
If the temperature is set above 120 °C within
the FRY program and above 130 °C in the
MULTI COOK program, cook with the lid open
Ensure that the power cord is connected to the
corresponding inlet on the housing of the appli-
ance and to the socket
Connect to a properly working wall socket
Check the power supply. If not available, contact
local electricity supply company
Ensure that the power supply is stable. If unstable/
underrated, contact local electricity supply com-
pany
Unplug the appliance and let cool down. Remove
foreign object or objects
Properly position the bowl into place
Unplug the appliance and let cool down. Clean
heating disk
Possible cause
The bowl is not properly posi-
tioned
Inner lid and cooking
The lid is not closed properly;
bowl fail to seal her-
foreign object under lid
metically
Sealing ring is dirty, deformed,
or damaged in any way
Environmentally friendly disposal (WEEE)
The packaging, user manual and the device itself shall be taken to the applicable collection point for the recycling
of electrical and electronic equipment. Do not throw away the electronic waste to help protect the environment.
Old appliances must not be disposed with other household waste but must be collected separately. Municipal
disposal of recyclable wastes is free of charge. The owners of old appliances are required to bring it to a waste facil-
RMC-M90E GBR
Solving the problem
Properly position the bowl into place
Remove foreign objects (grain, food particles,
debris, etc.) from under the rim, if any. Always
close the lid until it clicks into place
Check the sealing ring. Replace, if necessary
15