Maxi-Cosi Pebble 360 Manual De Instrucciones página 58

EN
A - Carrying handle
B - XL Sun canopy (built-in)
C - Push buttons for carrying handle
adjustment (L+R)
D - Belt hooks for lap part of belt (L+R)
E - Belt buckle with belt pad
F - Harness adjuster button
G - Storage compartment for user manual
H - Harness belt tensioner strap
I - Cover
J - Newborn inlay
K - Easy-in shoulder belts with removable
belt pads
L - Stroller release buttons (L+R)
M - Height adjustable headrest
N - Belt hook for shoulder part of belt
O - Mounting bars for base
SAFETY
The car seat is developed for an intensive use of
approximately 6 years.
Pebble 360 car use
• The car seat can be rotated by installing it on the
Maxi-Cosi FamilyFix 360 rotative base. It helps you to
get your child in and out of the vehicle easily.
• When the car safety belt is used, make sure the car
safety belt buckle runs in a straight line and stays below
the belt hook of the car seat.
• The car safety belt must be threaded tight along all
green markings. For a proper installation, check the
instruction in this manual and the sticker on the side of
the car seat.
• Only use a forward-facing seat that is fitted with a
3-point safety belt that complies with the ECE R16
standard.
I
58 Pebble 360 I Maxi-Cosi
WARNING:
• Install the car seat only rearward facing in the car on a
forward facing vehicle seat.
• The car seat must always be locked in the rearward
facing position when travelling. Do NOT travel when the
car seat is rotated to a lateral (loading) position or to
any other unlocked intermediate position.
Pebble 360 and your baby
• Make sure you can fit no more than one finger
between the harness and your baby (1cm). If there is
more space than 1 cm, tighten the harness belt further.
• Make sure the headrest is adjusted to the proper
height.
• Make sure that the shoulder harness belts are at the
correct height. The shoulder harness belts should be on
or just below the baby's shoulders.
• Only use the newborn inlay of the Pebble 360 until
your baby exceeds the 60 cm length limit. Afterwards
remove the newborn inlay from the Pebble 360.
WARNING:
Never place the car seat on an elevated surface (such as
a table or chair).
Using Pebble 360
• When Pebble 360 is installed on a stroller, always
make sure to use approved car seat adapters and to
secure Pebble 360 correctly.
• The height of the headrest and the shoulder harness
can be set simultaneously into 6 different positions.
Pull the headrest adjustment strap and meanwhile, pull
up or push down the headrest until it's in the correct
position.