Adopting The Correct Posture; Select The User Memory - Beurer BM 96 Cardio Instrucciones De Uso

Now insert the cuff line into the connection for the cuff connector.
The cuff is suitable for you if the index mark (
fitting the cuff.
If the measurement is performed on the right upper arm, the line should be located on the inside of
your elbow. Ensure that your arm is not pressing on the line.

Adopting the correct posture

• To carry out a blood pressure measurement, make sure
you are sitting upright and comfortably. Lean back and
place your arm on a surface. Do not cross your legs.
Place your feet next to each other flat on the floor.
• Always make sure that the cuff is at heart level.
• To avoid distorting the measurement, you should re-
main as still as possible during the measurement and
not speak.

Select the user memory

The device has two user memories. Each user memory can store up to 60* measured values of the two
categories blood pressure and ECG. Once all memory spaces in a user memory have been used, the
oldest measured values are replaced by the most recent.
• Press the START/STOP button
• Select the desired user by pressing the memory buttons M1 (for user
• Confirm your selection by pressing the START/STOP button
measurement or go to blood pressure measurement by pressing START/STOP button
* With 30-second measurement. Deviation possible in the event of a longer measurement duration.
) is within the OK range after
on the switched-off device.
49
) or M2 (for user
1
again. You can now proceed with ECG
).
2
again.