Cushman TITAN XD Manual Del Propietário página 14

SAFETY
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.
1
Turn key to ON
Select Forward
direction
Press accelerator
to start movement
Turn key to ON
Select Reverse
warning indicator
will sound
Press accelerator
to start movement
Cross slope
25% MAX
MAX ramp grade
25% or 14°
Do not operate
under influence of
drugs or alcohol
35216G01
Type EE Vehicle
One label each
side of vehicle
WARNING
Read the manual
2 passengers Secure
load as far forward as
possible MAX weight
2600 lbs or 1200 kg
X 2
P
X 4
Danger of
explosion
DO NOT
fill fuel can
on load bed.
4 passengers Secure
load as far forward as
possible MAX weight
2200 lbs or 1100 kg
1 - 8
WARNING
Read the manual
Turn key OFF
630651
Set parking brake
before leaving
Keep entire body
inside vehicle.
MAX
25%
Use caution in
inclement weather
630651
Do not drive
on highway
Do not
ride on
deck
MAX
2600 lbs.
1200 kg
MAX
2200 lbs.
1000 kg
600947
DO NOT
600947
short across
battery terminals
Load with high
center of gravity
may cause
tip over
vehicle
Forward
Neutral
Run
WARNING
Read the manual
WARNING
Explosive
NO
Sparks
630650
Parking
Brake Light
631074
Reverse
Read Manual
Tow
Maintenance
Storage
2
1
15A
630653
20A
Fuses
WARNING
630652
630652
Code Fault Code Symptoms
1-1 HW FAILSAFE Vehicle will not run
WARNING
1-2 THROTTLE FAULT 1 Vehicle will not run
1-3 SPEED SENSOR FAULT Vehicle runs slowly
Corrosive
1-4 HPD Vehicle will not run
1-5 MOTOR STALL Vehicle stopped
2-1 LOW BATTERY VOLTAGE Vehicle performance reduced Charge batteries, replace bad batteries
Regen performance reduced Check that battery voltage is less than 60 VDC
2-2 OVERVOLTAGE
Vehicle performance reduced Allow controller to cool
2-3 THERMAL CUTBACK
Vehicle runs slowly
2-4 MAIN DRIVER ON
2-5 VDD FAULT Vehicle will not run
Solenoid does not close
3-1 MAIN DRIVER OFF
3-2 MAIN WELDED Vehicle runs slowly
3-3 PRECHARGE FAULT Vehicle will not run
3-4 FIELD MISSING Solenoid closes, vehicle will
not run
Vehicle will not run
3-5 FIELD OVERCURRENT
4-1 CURRENT SENSE FAULT Vehicle will not run
4-3 M- FAULT Vehicle will not run
NO
Vehicle will not run
4-4 AUX CONT DNC
Vehicle runs slowly
4-5 WELDED AUX CONT
5-1 EEPROM FAILSAFE Vehicle will not run
Smoking 5-2 MAIN COIL OPEN Vehicle will not run
5-3 MAIN CONT DNC Vehicle will not run
5-5 MISSING CONTACTOR Vehicle stops
DIAGNOSTIC FAULT CODES
‹The LED will flash a diagnostic fault code when a fault is detected
‹Some faults may only be detected by operating the vehicle with the rear
of the vehicle raised and supported on safety stands
‹Always turn the 'RUN TOW/MAINTENANCE' switch (located in the
battery compartment) to the 'TOW/MAINTENANCE' position before
performing any repairs or maintenance to the vehicle
‹Select 'RUN' before returning the vehicle to service
OFF
ON
631074
Fuse numbers
and sizes
4 6 8 10
3 5 7 9
7.5 A 5A 15A 15A
2A
2A 15A 5A
630653
Pinch
point
629290
Corrective Action
Check motor wiring, replace controller
Check pedal box adjustment, connections,
replace ITS
Check speed sensor connection, and wiring,
replace sensor if required
Release and reapply pedal. Check pedal
box, linkage, switch and key switch
Remove mechanical blockage
Solenoid driver defective, replace controller
Replace controller
Replace controller
Verify solenoid welded, replace solenoid
Check for additional electronics attached to
B+, replace controller
Check wiring.
Replace power harness and motor if required.
Field windings or power harness shorted.
Verify, replace motor if necessary.
Replace controller
Check M- wiring and repair, replace controller
Replace controller
Replace controller
Replace controller
Check coil connections/wiring.
Replace solenoid if necessary
Check all solenoid wiring.
Replace solenoid if necessary
Check all solenoid wiring.
Replace solenoid if necessary
P/N 73398-G01
73398-G01