Anti-Stall Feature; High Pedal Disable Feature; Limp Home Feature; Starting And Driving - Cushman TITAN XD Manual Del Propietário

OPERATING PROCEDURES
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

Anti-Stall Feature

Anti-Stall protection prevents motor damage from stalling the vehicle against an object or on a hill.
Example: If all of the following events occur...
a) the system senses that the accelerator pedal is depressed (power applied to motor)
b) the motor is stalled long enough that any more time may cause motor damage
the Anti-Stall feature will momentarily interrupt power to the motor. This brief interruption will permit the car to roll
backwards slightly before again stopping in the stalled condition. This process will repeat itself periodically until the
car is moved from the stalled condition.
4
Example: If all of the following events occur...
a) the system senses that the accelerator pedal is depressed (power applied to motor)
b) the brake is engaged so as to prevent vehicle motion
the Anti-Stall feature will sense a stalled motor condition and remove power from the motor. When the brake pedal is
released, the car will roll backwards slightly before power is returned to the motor.

High Pedal Disable Feature

High pedal disable prevents undesired acceleration if the direction selector lever is changed, or the key is turned on
while the accelerator is depressed.

Limp Home Feature

In the unlikely event of certain electrical system failures, the Limp Home feature will default to a mode that will permit
the vehicle to operate, but at a very reduced speed.
This feature allows the vehicle to be driven back to its storage facility where the problem can be diagnosed.
The controller will flash fault codes that can be read by the technician.

STARTING AND DRIVING

To reduce the possibility of roll - back which could result in severe injury or vehicle damage, do
not release the service brake until motor has started.
All vehicles are equipped with an interlock system that disables the controller and prevents the vehicle from being
operated or moved while the charger is connected. Disconnect the charger cord from the receptacle and properly
store the cord prior to moving the vehicle.
To operate the vehicle:
• Apply the pressure to the brake pedal, place the key in the key switch and turn it to the ON position.
• Move the direction selector to the direction desired.
• Release the park brake.
• Slowly depress the accelerator pedal to start the motor. Release the brake pedal when the motor starts.
• When the accelerator pedal is released, the motor controls the deceleration. To stop the vehicle more quickly,
depress the service brake pedal.
4 - 6