Wheel Installation; Light Bulb Replacement; Headlight And Front Turn Signal - Cushman TITAN XD Manual Del Propietário

MAINTENANCE
Read all of this manual to become thoroughly familiar with this vehicle. Pay particular attention to all Notices, Cautions, Warnings, and Dangers.

Wheel Installation

To reduce the possibility of component damage, do not tighten lug nuts to more than 85 ft. lbs. (115 Nm) torque.
It is important to follow the 'cross sequence' pattern when installing lug nuts. This will assure even seating of the wheel against
With the valve stem to the outside, mount the wheel onto
the hub with lug nuts. Finger tighten the lug nuts (1) in a
'cross sequence' pattern. Tighten the lug nuts to 50 to 85 ft.
5
lbs. (68 to 115 Nm) torque in 20 ft. lbs. (27 Nm) increments
following the 'cross sequence' pattern.

LIGHT BULB REPLACEMENT

To reduce the possibility of premature bulb failure, do not touch new bulbs with bare fingers. Use clean, dry tissue or
paper towel to handle the glass portion of the bulb.

Headlight and Front Turn Signal

Tool List
Torx Driver, T-20 ..........................................................1
Loosen four torx head screws, back them out until the light bezel is free, remove bezel with screws captured in it.
Pull headlight out away from recess, locate the retaining clip on the back of the housing. Squeeze clip wires together
until free of latch edges and pivot out of the way and remove bulb housing from the lens, set lens aside.
Remove old bulb and replace with new 12V/55W, H3 bulb, be sure to use clean, oil free cloth to hold the new bulb,
never touch the bulb with bare hands.
Replace bulb and housing in the lens, latch retaining clip wires, making sure that wires are not caught between the
clip and the lens.
Place the bezel with the captured screws over the lens, with the word TOP located at the upper edge. Align lens and
bezel with the housing and start all four screws. Tighten screws alternately, making sure that the bezel is seated
against the housing.
5 - 6
the hub.
Tire/wheel style
may vary
'Cross Sequence'
1
4
Qty. Tool List
Clean Cloth ............................................................. 1
'Cross Sequence'
1
3
3
2
5
4
2
Qty.