Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
Figure 2
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
Teeth side
up.com/qr-product.aspx
against hitch
Tie down bracket and weldnut cover removal
1.
Use 17 mm socket to remove (2) bolts from tie down bracket on passenger side, see Figure 2. Return tie down bracket to vehicle owner.
2.
Remove plastic caps from 2 rearmost existing weldnuts on the driver side, (a couple light twists with a standard screwdriver makes this easier) remove the rearmost rubber plug from the hole between
the two weldnuts that were exposed earlier on the driver side.
Hitch installation
1.
Raise the hitch into position over existing weldnuts and install M12 bolt ① and conical washer ② (teeth side against hitch) into weldnuts.
2.
Tighten all fasteners with torque wrench to 76 Lb.-Ft. (103 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
*Bend exhaust heat shield as necessary to keep from touching the hitch.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2016 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 75540, 84540, CQT75540
THIS PAGE IS FOR RX350 ONLY
Frame
rail
Weldnut
Figure 1
Rear
Sheet 3 of 21
Fastener Kit: 75540F
①
Qty. (4)
Bolt
M12x1.25x40 CL10.9
②
Qty. (4)
Conical washer
1/2 ''
②
①
Fasteners
typical
②
both sides
①
75540NP
2-23-16
Rev. B
Publicidad
Tabla de contenido
