Troubleshooting - Cramer 40PHA Traducción De Las Instrucciones Originales

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
CLEANING AND LUBRICATION OF THE CUTTING
MEANS
Do not touch the cutting means until the battery has
been removed and the cutting means is completely
stationary.
To increase the efficiency and working life of the blades,
clean and lubricate them carefully after each work
session:
„ Place the machine in a stable horizontal position on
the ground.
„ Use a soft cloth to clean the blades, along with a
brush to remove more difficult dirt and debris.
„ Lubricate the blades by applying a light layer of
specific oil, preferably the non-pollutant type, along
the upper edge of the blade.
NUTS AND BOLTS
„ Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
„ Check regularly that the handles are fixed firmly.
STORING
STORING THE MACHINE
When the machine is to be stored away:
1. Remove the battery from its housing and recharge
it;
2. Mount the blade cover.
3. Wait until the motor is sufficiently cold;
4. Clean.
5. Check there are no loose or damaged components.
If necessary, replace the damaged components
and tighten any screws and loose bolts or contact
the authorised service centre.
6. Store the machine:
– in a dry place
– protected from inclement weather
– in a place where children cannot get to it
– making sure that keys or tools used for
maintenance are removed.
STORING THE BATTERY
The battery must be kept in a cool, shaded place
without humidity.
NOTE: If unused for any length of time, recharge the
battery every two months to prolong its working life.
English (Original instructions)
WARNING

TROUBLESHOOTING

PROBLEM POSSIBLE
CAUSE
The motor Battery is not
shuts down inserted or
whilst is inserted
working. incorrectly.
The machine
is damaged.
With the The machine
safety lock is damaged.
button and
trigger on,
the cutting
means does
not turn.
The cutting Insufficient
means blade
overheats lubrication.
whilst
working.
Excessive Loose or
noise and/or damaged
vibration is parts.
experienced
whilst
working.
The machine The machine
gives off is damaged.
smoke whilst
working.
3
SOLUTION
Make sure that the
battery is inserted
correctly.
Do not use the
machine Remove the
battery and contact a
Service Centre.
Do not use the
machine. Immediately
turn off the machine
remove the battery
and Contact a
Service Centre.
Turn off the machine,
wait until the cutting
means is stationary,
remove the battery
and lubricate the
blades.
Turn off the machine,
remove the battery
and:
– inspect for damage;
– check for and
tighten any loose
parts;
– have any damaged
parts replaced or
repaired with parts
having equivalent
specifications.
Do not use the
machine. Immediately
turn off the machine
remove the battery
and Contact a
Authorised Service
Centre.