Installation Warning - Invacare CareGuard 95-1 Instrucciones De Montaje, Instalación Y Funcionamiento

After ANY adjustments, repair or service and BEFORE use, make sure that
all attaching component parts are secure.
For Model Nos. 95-1, 95-2, and 90-2, ensure that the snap buttons fully pro-
trude through the same respective adjustment hole of each adjustable leg
before using. This ensures that the adjustable legs are securely locked in posi-
tion and an even height adjustment is achieved.
ASSEMBLING THE
SHOWER CHAIR
ATTACHING THE LEGS
NOTE: Refer to WARNINGS in the
SAFETY SUMMARY of this instruction
sheet.
NOTE: For this procedure, refer to
FIGURE 1 and FIGURE 2.
1. Remove all contents from the
package. For Model Nos. 95-1 and
95-2, put backrest to the side and
refer to Installing/Removing the
Backrest on page 4 after attaching
and adjusting the legs.
2. Place seat upside down on a stable
surface (floor, table, etc.).
3. Position one (1) leg over one (1)
socket in the seat and align.
4. Angle the leg slightly so the rear
corner enters the socket first as
shown in FIGURE 1.
5. Push the leg down and rotate leg to
front of socket until leg is fully
seated in socket.
CareGuard™Shower Chair

INSTALLATION WARNING

2
STEP 2
STEP 3
Leg
STEP 4
Rear
Corner
STEP 5
FIGURE 1 - ATTACHING THE
LEGS
Leg
Seat
Socket
Leg
Socket
Leg
Front of
Socket
Part No 1118360