Invacare CareGuard 95-1 Instrucciones De Montaje, Instalación Y Funcionamiento página 4

FIGURE 3 - ADJUSTING THE LEG EXTENSIONS
INSTALLING/REMOVING THE BACKREST
NOTE: Refer to WARNINGS in the SAFETY SUMMARY of this instruction sheet.
NOTE: For this procedure, refer to FIGURE 4.
INSTALLING
1. Before installing the backrest, attach and adjust the legs so the shower chair is
level. Refer to Attaching the Legs on page 2 and Adjusting the Leg Extensions
on page 3.
2. Position the backrest into the slot on the seat.
3. Push down on the backrest until it sits securely into the seat slot.
4. Check under the seat to ensure the compression tabs on the backrest protrude
beyond the seat slot. If they are visible, the backrest is attached properly. If they
are not, push the backrest further into the seat slot. Refer to Detail "A" in
FIGURE 4.
5. Before using, pull upward on the backrest to ensure the backrest is securely
attached and locked into place.
REMOVING
1. Locate the compression tabs underneath the seat.
2. Depress both compression tabs with one hand.
3. Using the other hand, hold the backrest handle and pull up and away from the
seat.
4. Release the compression tabs to avoid pinching and continue pulling the
backrest up until it is removed from the seat.
CareGuard™Shower Chair
Adjustment
Holes
4
Snap Button
Leg Extension
Part No 1118360