Motorola CLP Serie Manual De Instrucciones página 7

Note:During the cloning process no power is being applied to the Single-Unit Charger. The batteries
are not being charged. A data communication is being established between the two radios.
3. Turn ON the "Target Radio" and place it facing down into one of the Single-Unit Chargers.
4. On the "Source Radio", power the radio following the sequence : Press and hold the Push-to-
Talk (PTT) and the "-" Button simultaneously while turning the radio ON until you hear the
Cloning Tone.
5. Place the "Source Radio" facing down in its Single-Unit Charger with an Audio accessory, then
press and release Menu Button to start the cloning process.
6. After cloning is completed, the "Source Radio" sounds either a "pass" tone (cloning was
successful) or a "fail" tone (cloning process has failed). The pass tone sounds like a good key
"chirp" whereas the "fail" tone sounds similar to a "bonk" tone. (A tone is heard in no more than
5 seconds.)
Once you have completed the cloning process, you should turn the radios "OFF" and "ON" to bring
them to normal user mode (exit "clone" mode).
Charging Status LEDs
On the SUC, the radio charging pocket has an LED indicator. The LED indicators are grouped into
pairs to show which charging pockets are paired. The LED is red when the battery is charging, then
it turns to green once the battery is fully charged.
5
English