Attaching The Fan Blades; Installing The Light Fixture - Kichler HATTERAS BAY Manual Del Usuario

ATTACHING THE FAN BLADES

Step 1. Place a blade between a blade bracket and a blade bracket
medallion. Attach all three pieces using the screws , fiber washers and
iron washers provided. (Fig. 17)
Make sure the blade is straight when set on the blade bracket and the
medallion. Tighten each mounting screw and then repeat this procedure
for each blade.
Step 2. Attach each blade assembly to the motor using two mounting
screws for each blade assembly. (Fig 17)
NOTE: Make sure these mounting screws are securely tightened.

INSTALLING THE LIGHT FIXTURE

Step 1. Loosen the two screws on the mounting ring attached to the
motor shaft and "remove" and save the third screw. (Fig. 18)
Step 2. Loosen the padlocks on one side of the light fixture allowing the
lens holder to open.
Step 3. Place the key hole slots on the light plate over the two screws
previously loosened on the mounting ring.
Turn the light plate until it locks in place at the narrow section of the key
hole slots.
Tighten both key hole screws and replace the third screw previously
removed and tighten securely.
Screws
Blade
Fiber washers
Iron washers
bracket
medallions
Blades
Blade brackets
Screws
Fig. 17
Light fixture
60" HATTERAS BAY
Mounting ring
Padlocks
Screws
Fig. 18
PATIO LED | 15
TM