Wall Cleaning; Shutting Down; Spare Parts - Kärcher FRV 30 ME Manual Del Usuario

Wall cleaning

Figure 6, see cover page
 Unscrew the covering nut.
 Remove joint.
Figure 7, see cover page
 Attach hand spray gun.
 Tighten the union nut.
Figure 8, see cover page
CAUTION
A strong wastewater jet will emerge from
the hose connection. Do not use the sur-
face cleaner without a hose.
 Insert the hose into the hose connection
and secure by rotating.
 Route the other end of the hose to a
drain.
 Hold the appliance at the handle while
cleaning the wall.
 Guide the surface cleaner so that it re-
mains close to the surface to be
cleaned.

Shutting down

 After operation with hot water, operate
the surface cleaner with cold water for
two minutes to cool it down.
 If necessary, rinse the surface cleaner
and the suction hose with clear water.
 Protect the appliance against frost.
 Do not allow bristles to deform during
storage.
Note: In order to ensure a good suction re-
sult, please do not place the surface clean-
er FRV 30 onto the bristle crown after use.
To protect the brush bar from damages,
you can also remove it while storing the
FRV 30.
 Rinse the steering rollers with clear wa-
ter after use and spray with creeping oil
after they have dried.
8
Care
Accessories
Accessories
Hose fastener (suction
cup to install on smooth
surfaces)
Dirt catcher (coarse dirt
separator)
Hose support (wall
mount)
Brush crown
Extension hose
Troubleshooting
Rotation arm does not rotate:
 Check if the cleaning nozzles are dirty.
Vacuum performance decreasing:
 Bristle crown worn - replace bristle
crown.
 Suction channel/suction hose blocked -
clean suction channel and suction
hose.
 Injector nozzle blocked - clean the in-
jector nozzle.
Only use original accessories and spare
parts, they ensure the safe and trouble-free
operation of the device.
For information about accessories and
spare parts, please visit www.kaerch-
er.com.
– 3
EN
Order number
2.642-528.0
2.642-532.0
2.042-001.0
6.371-293.0
4.441-040.0

Spare parts