Dash Disassembly; Kit Preparation - Metra 95-6542 Instrucciones De Instalación

DASH DISASSEMBLY

1. Place the vehicle in park and apply the
parking brake.
2. With the key in the ignition position,
apply the foot brake and place the
shifter in low gear.
3. Tilt the steering wheel all the way down.
4. Unclip the entire dash bezel, unplugging
any wire harnesses necessary to allow
complete removal. (Figure A)
5. Remove the (2) 3/8" hex head screws
securing the radio, then unplug
and remove.
Continue to Kit Preparation
2
(Figure A)

KIT PREPARATION

1. Clip the radio bezel cut template onto
the factory dash bezel, and then mark
the inside of the opening. (Figure A)
2. Remove the template, and then carefully
cut along the lines. Set aside for
Kit Assembly.
3. Place the sub-dash cut template into the
radio cavity in the dash, and then mark
the inside of the opening. (Figure B)
4. Remove the template, and the lower left
speed clip from the cavity, then carefully
cut the shaded areas marked out with a
suitable cutting tool.
5. Insert the speed clip provided with the
kit into the lower left position where the
factory clip was removed.
Continue to Kit Assembly
Remove shaded area
(Figure A)
Remove shaded area
(Figure B)
|
1.800.221.0932 MetraOnline.com