Warranty Statement; Regulator Schematic - Spyder RS Manual Del Usuario

TROUBLESHOOTING CONT.
• Dirt or broken paint shell fragments in the receiver can cause the marker to have recocking issues.
Using a squeegee thru the upper portion of the receiver will remove most of the dirt or broken shell
fragments. Should this issue continue, (see disassemble / reassemble & cleaning internals) remove the
markers internals for complete cleaning.
• Using low quality paintballs can cause the marker to experience recocking issues because of the
shape of the paintballs.
HELPFUL TIP: Paintballs have a shelf life and can become too fragile for use.
HELPFUL TIP: Paintballs can take a different shape over time, so it would be wise to size the paintball
with your barrel.
ELECTRONIC GRIP TROUBLESHOOTING
If your marker is not shooting it may be due to one of the following problems:
Battery may need to be recharged.
The Battery Wire Harness is not properly attached to the circuit board.
The Coil Set Harness is not properly attached to the circuit board.
The Touch Switch Harness is not properly attached to the circuit board.
NOTE: If the Markers Electronics have any dirt or paint, Kingman recommends using an aerosol can of
air. Apply the can of air directly at the components that need cleaning.

WARRANTY STATEMENT

Kingman warrants the original retail purchaser that this product is free from defects in material and
workmanship under normal use and service for a period of (1) year from the original date of purchase.
Any Electronic Components in an Electronic Spyder marker are warranted for (6) months from the
original date of purchase. Kingman agrees to repair or replace (at its discretion) any product within (a
reasonable period of time). This warranty does not cover o-rings, cup seals, 9.6v rechargeable battery,
charger, scratches, nicks, normal wear and tear of parts, any modifications, normal fading of anodizing
and damage caused by dropping or hitting of products. This warranty shall not apply if it is shown by
a Kingman Technician that the consumer caused the defect or malfunction because of misuse. This
warranty only covers original factory parts. Any modifications or tampering of original factory parts
will VOID warranty and liabilities from Kingman. Any damage caused by water will not be covered
under warranty. Warranty repair can only be conducted by Kingman technician or Kingman authorized
technician. For warranty to be effective, consumer must return the enclosed warranty registration
card filled out, along with a copy of the purchase receipt, within (15) days of the original purchase
date. This warranty is not transferable. Paintball markers are non-refundable. This warranty will not
cover pick up, shipping, delivery, and/or house calls. If product needs repair, consumer will package
it carefully and send together with your name, address, phone number and a brief description of the
malfunction to:
Warranty Registration is also available at www.Spyder.tv
KINGMAN GROUP
Attn: Tech Department
14010 Live Oak Avenue
Baldwin Park, CA 91706 U.S.A.
www.kingman.com
FOR TECHINICAL SUPPORT
Our Technical Support Department is open Monday through Friday, from 8am to 5pm (PST), and can be
reached at (626) 430-2300.
www.spyder.tv
13
REGULATOR SCHEMATICS
#REG004
#REG005
#REG006
#SCR026
#REG007
English
#REG002
#ORG021
#REG003
#ORG018
#ORG022
14