Style selections MTVS2547SWL Manual De Instrucciones página 13

ASSEMBLY INSTRUCTIONS
14. Determine where mantel is to be placed and mark
location on the wall for the mounting bracket (II)
screw holes. Note: The mounting bracket (II)
should be positioned vertically. Drill (2) 3/16 in.
pilot holes into the wall. Insert a wall anchor (JJ)
into each hole in the wall. Then, insert and tighten
2 large screws (LL) through the mounting bracket
(II) and into the wall anchors (JJ). Do not
overtighten.
Hardware Used
II
Mounting Bracket
JJ Wall Anchor
LL Screw
15. Place the mantel so the mounting bracket (II)
on the back of the mantel is in line with the
mounting bracket (II) on the wall. Place one
end of the nylon strap (HH) down through each
mounting bracket (II). Bring both ends together
and slide the end of the nylon strap (HH)
through the slot in the other end until snug.
Pull down on the end until it locks into the slot.
Check to make sure the nylon strap (HH) is
securely laced and locked to the mounting
brackets (II).
Hardware Used
HH Nylon Strap
WARNING: Young children may be injured by
tipping furniture. The use of a tipping restraint
is highly recommended. This hardware, when
properly installed, could provide protection against
the unexpected tipping of furniture due to improper
use; however, this product is only a deterrent and
should not be used as a substitute for proper
supervision.
x 1
x 2
x 2
x 1
13 13
14
JJ
II
LL
15
WALL
HH
II
MANTEL
Lowes.com Lowes.com
II