Maintaining The Brush Roll; Troubleshooting - Bissell 2897 Serie Manual Del Usuario

Maintaining the Brush Roll

Go to support.BISSELL.com for tips on maintaining and replacing your vacuum.
1.
Turn the machine OFF and
press the Foot Release Button
to disconnect the Motorized
Cleaning Foot.
4.
Reattach Brush Roll by
inserting into the belt and
pressing in to place.

Troubleshooting

Below are some of the issues you may run into. If you don't see the issue you're experiencing
below, visit support.BISSELL.com.
Problem Possible Cause
Filter is dirty.
Vacuum
There is a clog in the vacuum.
won't pick
up dirt
Dirt Tank is not seated correctly.
Dirt Tank is full.
Dirt is
escaping Filter is missing or dirty.
from the
There is a clog in the vacuum.
vacuum
Wrong power mode is being used.
Brush Roll
Brush Roll has lodged debris or other
doesn't
entanglements, keeping the brush
rotate
from rotating.
WARNING
electrical outlet before performing maintenance or troubleshooting. Other maintenance or service not included in the manual
should be performed by an authorized service representative.
2.
Twist the bottom screws
with a coin to remove bottom
cover.
5.
Attach and secure bottom
cover.
Remedies
Remove and rinse the filters. Allow enough time to dry properly before reinserting.
Remove the foot and Extension Wand from the Hand Vacuum. Check for debris buildup
or clogs in each of these sections. Clear any debris or clogs before reassembling.
Remove the tank and reseat properly.
Empty the tank.
Check to see if the filter is in place. Clean if necessary.
Remove the foot and Extension Wand from the Hand Vacuum. Check for debris buildup
or clogs in each of these sections. Clear any debris or clogs before reassembling.
Make sure switch is pushed all the way to Carpet Cleaning Mode.
Unplug to reset brush motor, checking for and removing debris before turning ON. If
problem persists, disconnect foot, remove bottom cover and clear debris & suction path.
To reduce the risk of fire, electric shock or injury, turn power OFF and disconnect plug from
3.
Remove the Brush Roll
cover and clear any debris
from Brush Roll.
BISSELL.com 7