Du Pont QuickTwist WFQT27000 Serie Instrucciones De Instalación página 8

QuickTwist ™ Filter Replacement
1
Turn off the cold water shut-off valve to the Filter System
2 B
Turn each QuickTwist ™ Filter
the System Head. Discard the used QuickTwist
NOTE: Place a pan or bucket under the Filter System to catch any water drips.
3
Hold each new QuickTwist ™ Filter with the label facing to the left slightly. The two nozzles on top of each QuickTwist
should be toward the back of the QuickTwist
should be out to each side.
NOTE: When viewing the QuickTwist™ System Head from the front, the QuickTwist™ 1st Stage Filter must be positioned on the left
side (inlet side) and the QuickTwist™ 2nd Stage Filter must be positioned on the right side (outlet side).
4
Lift each QuickTwist ™ Filter straight up into the System Head until the two nozzles seat into the ports and the two extended
flanges on top of the QuickTwist
5
Turn each QuickTwist ™ Filter from left to right until it stops.
6
Turn on the cold water shut-off valve and the Faucet for Filtered Water
the troubleshooting information in Step 7 of the Installation Instructions.
7
Flush water through the Faucet for Filtered Water for approximately 10 minutes to flush out any air from the QuickTwist
Check for leaks once more before completion.
X
X
WFQT27000 /WFQT27300 Series
A
.
from right to left until it releases. Gently pull down on each used QuickTwist
™ Filters.
™ Filter. If holding properly, the two extended flanges on top of the QuickTwist
™ Filter are fully engaged into the System Head.
D
™ Filter to remove it from
and check for any leaks. If there are leaks, refer to
7
INLET
2
™ Filter
™ Filter
3
™ Filters.
INLET
4
5
A
OUTLET
B1 B2
1ST STAGE 2ND STAGE
FILTER FILTER
OUTLET
A
B1 B2
1ST STAGE 2ND STAGE
FILTER FILTER
B1 B2
V4.0