Optional Additional Functions; Fabrication Of Cast Form Parts; Exchange Of Fuses; Care And Maintenance - Dreve Drufosmart scan Instrucciones De Trabajo

Drufosmart scan

10. Optional additional functions

10.1 Fabrication of cast form parts

With the K-7 insert it is possible to
thermoform up to 7 resin bases for
the crown and bridge technique at the
same time. Fix the single dies by means
of a flexible blocking out material (e.
g. Fillin) in the holes of the K-7 insert.
Remove the nub plate from the insert
bowl and replace it by the K-7 insert.

11. Care and maintenance

Generally disconnect the unit from
mains supply before executing care
and maintenance.
Ideally cleaning is to be effected dryly
with a soft piece of cloth, if necessary
40
All further working steps as described
from point 7.1 on.
with a slightly humid sponge and a
mild cleaning liquid. Water and clean-
ing liquids must not get into the unit.
The O-rings should be greased regu-
larly with silicone grease.

12. Exchange of fuses

Disconnect the unit from mains sup- After exchanging the fuse insert the
ply. The fuse carrier is situated at the fuse carrier into the housing applying
rear of the unit, integrated in the mains slight pressure until the fixation latches
supply. noticeably.
In order to control or exchange the
fuses push the push catch of the car-
rier, keep it pressed and remove the
carrier from the unit.
Pull the defective fuse out of the clamp
carrier applying slight traction and
replace it by a new, equivalent one.
Important: Only use the fuse
strength indicated on the rear.

13. General advice

Repairs on the Drufosmart scan units · the unit is operated in accordance
may only be executed by experts. Dis- with these working instructions.
connect the unit from mains supply · extensions, new adjustments, changes
at any rate. Dreve company is only or repairs are executed by persons
responsible for the safety, reliability authorised by the company.
and performance of the unit, if:
As we are currently developing our
· the unit is exclusively used for the cor- products, we reserve the right for tech-
responding field of application. nical changes.
· operation is only carried out by
accordingly trained personnel.
41