Porter Cable CPLMC7580V2C Manual De Instrucciones página 9

Ocultar thumbs Ver también para CPLMC7580V2C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To Install Air Filter
Attach elbow to pump using bolts provided. Tighten until
snug. Insert threaded end of air filter assembly into elbow
and tighten until snug.
HOW TO SET UP YOUR UNIT
Location of the Air Compressor
Locate the air compressor in a clean, dry, and well ventilated area.
Located the air compressor at least 12" away from the wall or other
obstructions that will interfere with the flow of air.
Locate the air compressor as close to the main power supply as possible
to avoid using long lengths of electrical wiring. NOTE: Long lengths of
electrical wiring could cause power loss to the motor.
The air filter must be kept clear of obstructions which could reduce air flow
to the air compressor.
Anchoring of the Air Compressor
The air compressor MUST be bolted to a solid, level surface.
Hardware needed:
4 - Concrete anchors (not supplied)
4 - 3/8" Lag screw to fit concrete anchors (not supplied)
4 - 5/8" Washer (supplied)
- Shims (if needed)
1.
Place the air compressor on on a solid, level surface.
2.
Mark the surface using the holes in the air compressor feet as a template.
3.
Drill holes in the surface for the concrete anchors. Install concrete anchors.
4.
Line-up holes in surface with holes in air compressor feet.
5/8" Washer
(supplied)
Shim Under
Washer
(not supplied)
INSTALLATION
Excessive Vibration can weaken the air tank and cause an
explosion. The compressor must be properly mounted.
3/8" Lag
Screw
(not supplied)
Surface Line
Concrete Anchor
(not supplied)
9- ENG
D24225

Publicidad

Tabla de contenido
loading

Tabla de contenido