Publicidad
Idiomas disponibles
Idiomas disponibles
13. DO NOT USE POWER TOOLS THIS CAN DESTROY THE HUB PULLER AND WILL VOID THE WARRANTY
14. ALWAYS LUBRICATE THE PRESSURE SCREW AND NUT WITH HIGH PRESSURE GREASE OR ANTI-SEIZE.
BEARING REMOVAL FROM SPINDLE/BEARING HOUSING
15. Some Vehicles Have Bearings with a Snap Ring or Other Type of Retainer, This Will Have to be Removed Prior to Removing the Bearing.
16. Select the Adapter Sleeve That Best Fits Your Housing and Will Allow the Bearing to Pass Through.
17. Select the Smallest Step Washer that Will Not Pass Through the Bearing.
18. Assemble Components as Shown in Figure # 2 Tightening Tapered Nut Against the bearing.
19. Hold the Tapered Nut While Turning the Pressure Screw. Continue turning to extract the bearing.
20. In Some Cases, the Inner Bearing Race Will Remain in the Hub, Remove This Prior to Re-Assembly
21. An Alternative Method for Bearing Removal / Tool Set-Up is to Use the Horseshoe Bracket Assembly to Push Against the Spindle Bearing
Support Plate 5
Figure 2
Bolt
Bearing
Spacer Ring 4
Adapter Sleeve
9, 10,11
3
Bearing Housing
Nut 2
Stepped Washer 5, 6, 6H,
7, 7H, 8, 8A,12, 13, 14
Publicidad
