Hanging The Fan - Beacon Lighting LUCCI Manual Del Usuario

Airfusion Radar Installation Instructions
If there isn't an
existing outlet box,
•
Disconnect the power by removing the fuses or turning off the circuit breakers.
•
Secure the outlet box (A) (not included) directly to the building structure. Use appropriate fasteners and
materials (not included). The outlet box and its bracing must be able to fully support the weight of the
moving fan (at least 35 lbs). Do not use a plastic outlet box.
•
Figures 2-3 below show three different ways to mount the outlet box (A) (not included).
NOTE: The ceiling fan must be installed in a location so that the blades are 300mm from the tip of the blade
to the nearest objects or walls.
To hang your fan where there is an existing fixture but no ceiling joist, you may need an installation hanger
bar (C) as shown in Fig. 4. Make sure the hanger bar you purchase has been designed for use with ceiling
fans.
INSTALLING THE MOUNTING BRACKET
Pass the power supply wires (C) from the ceiling outlet box (B) through the center of the ceiling mounting
bracket (D). Install the ceiling mounting bracket (D) on the outlet box (B) with the mounting screws (F) provided
with the outlet box and washers (E) provided with fan. Fig. 5
3 | P a g e
INSTALLING THE MOUNTING BRACKET
then install one using the following instructions:
Fig. 2

HANGING THE FAN

Fig. 3
Fig. 4
Fig. 5
C T