Using Your Ceiling Fan - Beacon Lighting LUCCI Manual Del Usuario

Airfusion Radar Installation Instructions
LIGHT KIT INSTALLATION (Light kit sold separately)
Note: Light kit must be installed by a licensed electrician.
NOTE: The light kit is available for selected ceiling fan models and as
an optional light kit.
1. Remove the bottom cover from shaft (A).
2. Remove the shrinkable tube (B) from light wires connector (C).
3. For light kit installation, please refer to light kit installation user
guide.
Pairing Transmitter and Receiver – when 2 or more DC ceiling fans are installed in one location
When two or more fans are located near each other, you may want to have the receiver/transmitter for each
fan set to a different code, so that the operation of one fan does not affect the operation of the other fan/s.
The DIP switches for the transmitter (remote hand piece) are located in the battery compartment of the
transmitter. Configuring the DIP switches will allow a unique transmission code assigned to each fan ceiling.
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE: Ensure power to the receiver is ON prior to pairing the transmitter with the receiver.
Transmitter / Receiver pairing for Ceiling fan 1:
⚫ Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
⚫ Install the 12V DC battery in the compartment. Please make sure the polarity of the battery is correct.
Fig.11
Change the position of the DIP switches in the transmitter 1, so that it will be different to transmitter 2.
⚫
⚫ Turn on the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
⚫ Press and hold the "SET" button of transmitter 1 for 6 seconds within 60 seconds of switching the power
ON to the receiver of ceiling fan 1.
While pairing the DC fan remote and receiver is in process, the fan will automatically start to rotate in the
counterclockwise direction and on the highest RPM for 3 minutes. When counterclockwise rotation has
finished, the fan will automatically reverse to clockwise direction to the highest RPM for 3 minutes. Fan
will turn off when the pairing process has finished. During the pairing process, the remote is non-functional.
⚫ Turn ON and change the speed of the ceiling fan 1 by the transmitter 1 to check the operation and
successful pairing.
6 | P a g e
Fig. 10

USING YOUR CEILING FAN

C T