900Ct-380 Function Table - Key Automation 900CT-380 Manual De Instrucciones

DISPLAY DATA DESCRIPTION
t.AP 0.0" ÷ 2.0' Gate opening time
t.APP 0.0" ÷ t.AP1 Opening time of pedestrian gate
t.Ch 0.0" ÷ 2.0' Gate closing time
t.ChP 0.0" ÷ t.Ch Closing time of pedestrian gate
t.PrE 0.5" ÷ 2.0' Pre-flashing time
no - Pre-flashing disabled (it corresponds to 0)
St.AP Start in opening
no - Start command is not available
ChiU - Command close gate
PAUS - Stop the gate and goes in pause
St.Ch Start in closing
Stop - Start command stop the gate
APEr - Start command open the gate
St.PA Start in pause
no - Start command is not available
ChiU - Start command closes the gate
SPAP Pedestrian in opening
no - Pedestrian start command is not available
ChiU - Pedestrian start command closes the gate
PAUS - Gate goes in pause
Ch.AU Automatic closing
no - The gate closes after the setup time)
0.5"÷ 20.0' - The automatic closing is not active (it corresponds to 0)
Ch.tr Closing after passage
no - Closing after passage disabled
0.5"÷ 20.0' - Gate stop for a time to be set between 0.5" to 20'
PA.tr no/Si Pause after transit
LP.PA no/Si Flashlight in pause
St.rt Operation modes
StAn - Start inputs from terminal board are disabled
no - Standard operation
AP.CH - Separated opening and closing commands
PrES - Manned operation
oroL - Timer operation
FrEn no/Si Brake function
StoP STOP input
no - STOP input not available
invE - STOP command stops the gate: START command starts moving in the opposite
ProS - STOP command stops the gate: pressing the START command gate continues the

900CT-380 FUNCTION TABLE

direction
motion
34
MEMO
DEFAULT
DATA
15.0"
6.0"
16.0"
7.0"
1.0"
PAUS
StoP
ChiU
PAUS
no
no
no
no
StAn
no
no