Du Pont WFPF13003B Manual De Instalación página 5

STEP
3
STEP 3
Assemble the System and Install Mounting Bracket
Assemble the System and Install Mounting Bracket
1
Dry assemble the complete system (according to the configuration chosen), including all fittings and valves.
2
Measure the overall length (see diagram) of the configured system.
1
Dry assemble the complete system (according to the configuration chosen), including all fittings and valves.
3
Reduce this measurement enough to allow for the amount of engagement (X) to determine how much pipe to remove from the line.
2
Measure the overall length (see diagram) of the configured system.
3
Reduce this measurement enough to allow for the amount of engagement (X) to determine how much pipe to remove from the line.
4
When installing the Mounting Bracket
4
the System Head. Insert the four 3/4" Mounting Screws
When installing the Mounting Bracket
until tight.
System Head. Insert the four 3/4" Mounting Screws
STEP 4
STEP
4
Mark Measurements and Cut the Plumbing Pipe
Mark Measurements and Cut the Plumbing Pipe
CAUTION CAUTION
Please wear safety glasses to protect
1
Mark the section of the plumbing pipe that will need to be removed (X) to allow for the configured system (as determined in Step 3).
eyes when cutting.
NOTE: Measure twice, cut once!
2
Using a pipe cutter or hacksaw, cut the marked section from the plumbing pipe.
NOTE: Use a pan or bucket to catch any remaining water in the pipes.
1 Mark the section of the plumbing pipe that will need to be removed to allow for the configured system (as determined in Step 3).
3
Remove any burrs or debris from the cut edges with a file.
NOTE: Measure twice, cut once!
2
Using a pipe cutter or hacksaw, cut the marked section from the plumbing pipe.
NOTE: Use a pan or bucket to catch any remaining water in the pipes.
3
Remove any burrs or debris from the cut edges with a file.
WFPF13003B
WFPF13003B
E
, position it on top of the System Head
E
through the Mounting Bracket and into the holes of the System Head
F
, position it on top of the System Head
F
through the Mounting Bracket and into the holes of the System Head until tight.
Please wear safety glasses to protect eyes when cutting.
A
, aligning the bracket holes with the holes in
A
, aligning the bracket holes with the holes in the
4
5
3
3
2
3
X
E
A
SEE CHART
PAGE 3
F
E
A
A
4
4
V4.0
V4.1I