Adjusting The Beam - ETI Solid State Lighting GROW ELITE GL-72-MV Guía De Uso Y Cuidado

installation (continued)
4
Plugging into a power supply
□ Plug the power cord (B) into the end of the grow light (A)
and then plug the other end of the power cord (B) into an
electrical outlet.
□ Attach the power cord to the aircraft cable (sold
separately) with cable ties (not included).
□ Secure the power cord to the ceiling using cord clips or
cable raceway (not included), if applicable.
□ Use the power switch to activate the fixture.
CaUtiOn: When suspension mounting, make sure the
light fixture is located directly below the electrical outlet.
Excess cord should be secured to the aircraft cables (sold
separately) with cable ties (not included).
5
Choosing the light spectrum
This LED grow light allows you to choose the preferred light
spectrum.
□ Flip the spectrum
switch to select
either the Vegetating
light spectrum or
the General light
spectrum.
Spectrum Switch
B
A
Power switch
6

Adjusting the beam

This LED grow light provides down or side illumination with
rotating light bars.
A
□ Rotate the bars on each side of the grow light (A) to
the desired position.
5
Please contact 1-855-384-7754 or further assistance.
Aircraft Cables
WWW.ETiSSL.COM