Monogram ZV830 Instrucciones De Instalación página 15

INSTALLATION—RECIRCULATING
2
INSTALL HOOD MOUNTING
SCREWS
The mounting screws must enter the horizontal
support or wall studs.
mark mounting bracket screw locations.
the lower bracket.
between the screw head and the wall. This will
allow the keyhole slot on the hood frame to engage
the screw head.
1-1/4"
NOTE: Top
mounting
screws MUST
engage wood
support.
9-7/16"
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
IMPORTANT: Use the mounting screws provided. DO
horizontally level.
3
INSTALL DUCT BRACKET
The duct bracket should be installed against the back
wall and flush with the ceiling. This bracket will hold
the duct cover in place at the top.
Secure the bracket to the wall:
to the penciled centerline on the wall.
holes to 3/8" and install metal wall fastener anchors
(provided).
install per the fastener supplier's instructions.
into the fasteners to allow
the screws.
wall with wood screws and/
or fasteners.
49-80512 Rev. 4
Installation Instructions
1-1/4"
10-1/16"
TOP TOP
MOUNTING MOUNTING
HOLE HOLE NOTE: Top
mounting
DRILL 1/8" DRILL 1/8" screws MUST
engage wood
PILOT HOLE PILOT HOLE
support.
REAR WALL
MOUNTING TEMPLATE
15-7/16" 15-7/16" 9-7/16"
C L
BOTTOM
MOUNTING
HOLE
Installation Height
Align Bottom Edge With
Pencil Line Indicating
Bottom of Hood
Centerline
cutout
4
MOUNT THE HOOD
WARNING
2 people are required to lift and
position the hood onto the mounting screws.
(provided).
the wall.
Tighten
screws
Install
screws
15