Harbor Breeze 00728 Manual De Instrucciones página 4

ASSEMBLY INSTRUCTIONS
1. Attach mounting plate (A) to outlet box (not
included) using two screws (not included).
Securely tighten two outlet box screws. Pull
black, white, and grounded wires out of outlet
box and through the hole in the mounting
plate (A).
2. Place trim ring (C) over canopy, and lay it on
fan motor (B).
3. Loosen two preassembled screws across from
each other on the mounting plate (A). Remove
and save remaining two preassembled
screws. Hang fan motor (B) on mounting plate
(A) hook using one of the non-slotted holes in
the canopy.
IMPORTANT: Do NOT use this fan with a
dimmer switch or variable speed wall control.
Using a dimmer switch or variable speed wall
control will damage the fan.
ON
ON / OFF NO Variable NO Dimmer
switch speed wall
control
1
Screw
2
B
3
Screw
Hook
switch
6
ASSEMBLY INSTRUCTIONS
4. Connect the BLACK wire from the fan to
the BLACK wire from the ceiling. Connect
the WHITE wire from the fan, to the WHITE
wire from the ceiling. Connect all GROUND
Outlet
(GREEN) wires from the fan together to the
box
GREEN/BARE wire from ceiling. Connecting
the GREEN/GROUND wires is conducive to
receive the signal of the remote control.
NOTE: The BLACK wire is the hot power for the
fan and light kit. The WHITE wire is common for
fan and light kit. GREEN wire is the ground wire.
lf the household wires are different colors than
A
referred to above, stop immediately and consult a
professional electrician to determine proper wiring.
5. Twist wire ends together and screw wire
connectors (AA) on in a clockwise direction.
C
Tape wire connectors (AA) and wires together
with electrical tape (not included).
Hardware Used
Canopy
AA
Wire Connector
6. Align keyhole slots on the fan motor (B) with
the protruding screw heads on the mounting
plate (A). Lift the fan motor (B) up to the
mounting plate (A), making sure not to break
A
any wire connections. Rotate the fan motor
Canopy
(B) clockwise until the screw heads fully
engage into keyhole slots. Insert the previously
removed screws (Step 3, page 6) and securely
B
tighten all the screws.
4
Ground/
Green
White
Black
5
x 3
AA
6
A
7
Supply
Circuit
Outlet box
Green/
Grounded
Receiver
Screw
B