Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
4. For Three-Hole Installation:
Position base plate (E) into deck plate (B) and position
base deck onto sink deck. From underneath the sink,
thread the deck mounting nuts (BB) flat side up until lightly
snug.
Position the faucet over the hole so that the red marked
supply line is to the left and the blue marked supply line is
to the right. Insert the faucet shank into the deck plate
making sure the two cut outs in the base of the faucet (A)
seat onto the locking tabs that protrude from the base
plate (E).
Hardware Used
AA
Mounting Bolt
BB
Deck Plate Mounting Nut
5.
From under the sink feed the supply lines and the spray
hose through the rubber washer (DD). Slide the rubber
washer up onto the shank.
Feed the supply lines and the spray hose through the
mounting nut (CC). Thread mounting nut onto the shank
and lightly snug.
From the top of the sink make sure the faucet is properly
centered. Hand tighten the mounting nut (CC) until the
faucet (A) is secured.
Hardware Used
DD
Rubber Washer
Center Mounting Nut
CC
6. Connect the hot water supply line (not included) to the inlet
supply line of faucet (A) that has the red marking. Then
connect the cold water supply line (not included) to the inlet
supply line that has the blue marking.
NOTE: The inlet supply line fittings have standard 1/2 in.
MIP threads.
x 2
x 2
x 1
x 1
5
4
B
BB
5
CC
6
Red
Marking
Hot
Supply
Line
A
AA
DD
Blue
Marking
Cold
Supply
Line
Publicidad
