Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
10. Lightly extend and retract the pullout spray hose (D) to
make sure it does not catch or snag. Then fine tune the
retraction of the pullout spray hose (D) by moving the
weight (I) up or down a short distance until a smooth and
easy retraction is obtained.
11. Position the handle of faucet (A) downward into the
closed position. Slowly turn on the hot and cold water
supply valves and check for leaks.
12. Remove pullout spray wand (C) from pullout spray hose
(D) and set it aside. Firmly hold pullout hose (D) and
point downward. Slowly turn on handle of faucet (A) so it
is in the hot position and let it run for 1 minute. Do the
same for the cold water and then reconnect the spray
wand (C) to the pullout hose (D).
10
11
12
7
D
C
D
Publicidad
