Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Locate the male threaded end of the pullout spray hose (D).
Attach pullout spray hose (D) to center brass hose nut.
Hand tighten.Then lightly wrench tighten 1/4 turn, or until
snug.
8. Hand tighten pullout spray wand (C) to cone shaped nut on
the other end of the pullout spray hose (D). Position pullout
spray wand (C) into spout.
9. Position the gripper sleeve (J) onto the pullout spray hose
(D) approximately 3 in. up from where the hose starts to
bend upward toward the pullout spray wand (C). Position the
weight (I) over top of the gripper sleeve (J) and secure
weight to hose using the 2 self-tapping screws (GG).
Hardware Used
GG
Self-Tapping Screw
x 2
6
7
Red
Marking
8
D
9
I
GG
Blue
Marking
D
C
J
D
Publicidad
