JANE nurse GIRO 360 Manual De Instrucciones página 21

GIRO
GB
360
6 USE FOR GROUP 0+ 1 (0-18KG)
Installation for group 0+ I: ISOFIX + TOP TETHER
For group 0+ I (from birth up to 18 kg, from birth up to 4 years), the child safety seat should be installed
in the rear facing position, using the ISOFIX connectors and the anti-rotation strap to attach the safety
seat to the vehicle seat. And then use the 5-point seat belt to secure the child.
Step 1: Pull the rotation button to turn the child safety seat frame from the forward facing position
to the rear facing position, and make sure it is securely locked into the rear facing position. Pull the
reclining position adjustment button to set the seat frame to the totally reclined position. Check that
the arrows point towards the blue marks.
Step 2: Position the child safety seat firmly against the backrest of a forward facing vehicle seat.
Step 3: Installing the ISOFIX system.
Release the ISOFIX system and pull the head block out as far as possible. Connect the ISOFIX
connectors to the ISOFIX anchors of the vehicle until the indicator changes from red to green and
you hear them click into place.
Then push the safety seat against the backrest of the vehicle seat until it is firmly in place.
IMPORTANT: Check that the indicator on both sides of the ISOFIX telescopic arms is GREEN. If the
indicator is red, push or pull the child safety seat.
To remove the safety seat, release the anti-rotation strap and press the red buttons on both sides of
the ISOFIX connector to release the ISOFIX anchors of the vehicle.
Step 4: Installing the anti-rotation strap.
The anti-rotation strap is found on the top part of the backrest of the seat. Pull it out completely
pressing the tension adjuster. Find the fastening point in the vehicle that may be found on the rear
parcel shelf, behind the seat or in the boot area, and hook the strap on. Tighten the fastening strap
until the indicator turns green.
Step 5: Place the child in the child safety seat, making sure that the child's back is flat against the
backrest of the seat. Use the 5-point seat belt to fasten the child in and make sure that the buckle
of the safety harness is correctly fastened and that the shoulder straps are at the correct height for
the child.
ATTENTION: Always use the fully reclined position for group 0+; then when the child weighs more
than 13 kg, use the child safety seat in the forward facing position.
7
USE FOR GROUP I (9-18KG)
Installation for forward facing Group I: vehicle belt + ISOFIX
For group I (9-18 kg, from 9 months to 4 years), this child safety seat should be installed in the forward
facing position, using the vehicle seat belt to secure the child safety seat and the 5-point safety
harness to secure the child.
NOTE: the ISOFIX system is optional for group I.
Installing the ISOFIX system.
Release the ISOFIX system and pull the head block out as far as possible. Connect the ISOFIX
connectors to the ISOFIX anchors of the vehicle until the indicator changes from red to green and
you hear them click into place. Then push the safety seat against the backrest of the vehicle seat until
it is firmly in place.
O
21