JANE nurse GIRO 360 Manual De Instrucciones página 22

GIRO
GB
360
IMPORTANT: Check that the indicator on both sides of the ISOFIX telescopic arms is GREEN. If the
indicator is red, push or pull the child safety seat.
To release and remove the safety seat, release the anti-rotation strap, pull the red ISOFIX handle on
the front part of the safety seat and pull the seat forwards. Press the red buttons on both sides of the
ISOFIX connector to release the seat from the ISOFIX anchors of the vehicle.
Step 1: Pull the rotation button to turn the safety seat frame forwards and make sure you lock it into the
rear facing position. Pull the reclining position adjustment button to set the frame of the child safety
seat to one of the central reclining positions, 2, 3 or 4. Make sure that the arrows point to the red marks
on the base of the seat.
Step 2: Unfasten the buckle and remove the insert (the insert is not needed for children over 13 kg).
Position the child safety seat firmly against the vehicle backrest facing forwards (fig. 6).
Step 3: Pull the diagonal section and the lap belt of the vehicle seat belt until extended as far as
possible, slot the diagonal part of the vehicle seat belt through the belt guide on the headrest while
passing the lap belt section through the slot marked red. Pass the 2 parts (diagonal section and lap
belt) through the padding on the backrest from one side to the other.
Step 4: Tighten the vehicle seat belt by first pulling the lap belt section and then the diagonal part in
the direction shown in the diagram. Make sure that the vehicle seat belt is not twisted.
Step 5: Place the child in the child safety seat, making sure that the child's back is flat against the
backrest of the seat. Use the 5-point seat belt to fasten the child in and make sure that the buckle of the
safety harness is correctly fastened and that the shoulder straps are at the correct height for the child.
For group I, always use the reclining position 2, 3 or 4 for the forward facing position.
8
USE FOR GROUP II and III (15-36 KG)
Installation for group II, III: vehicle seat belt +ISOFIX
For group II and III (15-36 kg, 3-12 years), this child safety seat should be installed facing forwards, using
the vehicle seat belt to secure both the child and the safety seat.
Note: The ISOFIX system is optional for group II and III.
Step 1: Before installing the seat, unfasten the buckle, remove the 5-point safety harness (shoulder
straps, crotch strap and lap belt, fig. A and B), and take the buckle off removing the metal part found
underneath the cover (fig. C).
Step 2: Pull the rotation button to turn the safety seat frame forwards and make sure you lock it into the
rear facing position. Pull the reclining position adjustment handle to set the frame of the child safety
seat to reclining position 1. Make sure that the arrows point to the red marks on the base of the seat.
Step 3: Place the child safety seat firmly against the backrest of the vehicle seat facing forwards.
Step 4: Place the child in the child safety seat, making sure that the child's back is flat against the
backrest of the seat. Pull the 3-point vehicle seat belt and slot the diagonal part of the belt through
the belt guide on the backrest while the lap belt section goes through the slot marked red. Make sure
that both the diagonal part and the lap belt go through the slot marked red on the other side before
fastening the vehicle seat belt.
22
O