For Products Using Water Carboy; Water Filter - Beko GN163120X Manual De Instrucciones

Installation
4. Attach the connector into the faucet adaptor
and tighten by hand / tool.
5. To avoid damaging, shifting or accidentally
disconnecting the hose, use the clips provided
to fix the water hose appropriately.
A
WARNING:
on, make sure there is no water leak on
either end of the water hose. In case of
leakage, turn the valve off and tighten
all connections using a pipe wrench or
pliers.

3.8. For products using water carboy

(Optional)
To use a carboy for the product's water
connection, the water pump recommended by the
authorized service must be used.
1. Connect one end of the water hose provided
with the pump to the product (see 3.6) and
follow the instructions below.
After turning the faucet
2. Connect the other end of the water hose to
the water pump by pushing the hose into the
pump's hose inlet.
3. Place and fasten the pump hose inside the
carboy.
4. Once the connection is established, plug in
and start the water pump.
C
Please wait 2-3 minutes after starting
the pump to achieve the desired
efficiency.
C
See also the pump's user guide for
water connection.
C
When using carboy, water filter is not
required.

3.9 Water filter

(Optional)
The product may have internal or external filter,
depending on the model. To attach the water filter,
follow the instructions below.
10 / 34 EN
Refrigerator / User Guide