Peavey Vypyr VIP Serie Manual De Instrucciones página 27

5 6
pre-gain low
P1 P2
edit mode
tap tempo
12
ampS ENCODEr
3
Turn this knob to select your amp model. Each amp has 3 channels: if the LED is red, you are on the high
gain channel, yellow for medium gain and green for low gain. When you are using an acoustic preset (Item 1,
Bank C) only the acoustic amplifiers will be available. If you are using a bass preset (Item 1, Bank D) only the
bass amplifiers will be available. Press and hold for 2 seconds to enter tuner mode.
The LEDs around the Amp encoder will tell you what note you are tuning. At the same time the LEDs around
Effects encoder (Item 4) will indicate whether the note is sharp or flat. If the LED is to the right of the 12:00
position you are sharp (tune down). If the LED is to the left of the 12:00 position you are flat (tune up).
When all of the LEDs around the Effects encoder come on, you are in tune.
EFFECtS ENCODEr
4
Turn this knob to select any "Rack" effect. These are effects you might find attached to the effects loop of an
amplifier. Press the encoder momentarily to enter Edit mode.
prE GaIN
5
Turn this knob to crank up the gain—think of it as how much distortion you want out of the amplifier. In Edit
mode this knob controls parameter 1 of either the selected Stompbox or Effect.
LOW ENCODEr
6
Low EQ adjustment. In edit mode this knob controls parameter 2 of either the selected Stompbox or Effect.
mID ENCODEr
7
Mid EQ adjustment. In edit mode this knob controls the Feedback of the Delay effect. Feedback is the
number of times the delay repeats.
7 8
mid high
delay feedback delay level
VYPYR ®
13
9 10
post-gain
6
5
4
3
2
1
0
USB aux in
reverb level
VIP-2
14 15
27
7
8
9
master
10
volume
11
12
13
phones
16