Power Switch - Peavey Vypyr VIP Serie Manual De Instrucciones

Engineering Notes
8 pIN mIDI
0
Connect your Sanpera
Sanpera foot controllers and is required for their operation.

pOWEr SWItCH

1
This two-way rocker switch applies power to the unit when placed in the ON position.
CautION: The on/off switch in this unit does not break both sides of the primary mains. Hazardous engery
can be present inside the chassis when the on/off switch in in the OFF position.
aC pOWEr INLEt:
2
This is the receptacle for an IEC line cord, which provides AC power to the unit. Connect the line cord to
this connector to provide power to the unit. Damage to the equipment may result if improper line voltage is
used. (See line voltage marking on unit).
Never break off the ground pin on any equipment. It is provided for your safety. If the outlet used does not
have a ground pin, a suitable grounding adapter should be used and the third wire should be grounded
properly.
To prevent the risk of shock or fire hazard, always make sure that the amplifier and all associated
equipment is properly grounded.
NOtE: FOr u.K. ONLy
As the colors of the wires in the mains lead of this apparatus may not correspond with the colored markings
identifying the terminals in your plug, proceed as follows:
(1) The wire which is colored green and yellow must be connected to the terminal which is marked by the
letter E, or by the Earth symbol, or colored green or green and yellow. (2) The wire which is colored blue
must be connected to the terminal
which is marked with the letter N, or the color black. (3) The wire which is colored brown must be connected
to the terminal which is marked with the letter L, or the color red.
0
®
I or Sanpera II here. This particular style of MIDI jack provides power to the
44
1
2