Peavey Vypyr VIP Serie Manual De Instrucciones página 32

VIp 3 Front panel
HIGH ENCODEr
8
High EQ adjustment. In edit mode this knob controls the Level or amount of Delay effect. All the way to the
left is zero and all the way to the right is max.
pOSt GaIN
9
This is the individual preset volume. In Edit mode this knob controls the amount of Reverb.
maStEr VOLumE
10
Turn it up, ours goes to 13!
pOWEr SpONGE
11
This knob allows you to reduce the power output of the amplifier. Don't confuse this with the Master
Volume control. Power Sponge adjusts the amount of power the amp is capable of producing. This circuit
allows you to get that full on cranked sound at bedroom levels. The Power Sponge can adjust the maximum
output of the power amp from 100 Watts all the way down to 1 Watt.
12
LOOpEr INDICatOr
This function requires a Sanpera
the looper will allow you hours and hours of fun. You can record any 30 plus seconds of anything, switch
your tone (preset), and play over top of your recording. For example, try recording a bass track, then
change your tone to a lead tone and play over the top! Note the LED that corresponds to the looper on the
encoder will turn on when recording or playing back the loop.
EDIt mODE
13
Edit mode simply changes the 5 amp controls to their alternate function as listed on the bottom of the
encoder. When in Edit mode the Edit mode LED will either be green if you are editing Effects, or red if you
are editing Stompboxes. To enter Edit mode simply press either the Stompbox encoder (Item 2) or the
Effects encoder (Item 4). To exit Edit mode simply press the same encoder again.
0
guitar
input
turn to search
press to select
®
I or Sanpera II foot controller. Waste no time in making that purchase—
1
presets
preset name
inst/stomp
push to edit/hold to bypass
2
32
model presets
amplifiers effects
push to select channel/
push to edit/hold to bypass
hold for tuner/menu
3 4
pre
e
looper
12