Install The Header Bracket - Craftsman 139.53989 Manual Del Propietário

INSTALLATION STEP 2
Install the Header Bracket
You can attach the header bracket either to the wall
above the garage door, or to the ceiling. Follow the
instructions which will work best for your particular
requirements. Do not install the header bracket
over drywall. If installing into masonry, use
concrete anchors (not provided).
WALL HEADER BRACKET INSTALLATION
• Center the bracket on the vertical centerline with
the bottom edge of the bracket on the horizontal
line as shown (with the arrow pointing toward the
ceiling).
• Mark the vertical set of bracket holes. Drill 3/16"
pilot holes and fasten the bracket securely to a
structural support with the hardware provided.
Wall Mount
OptionaI
Mounting Holes
2x4
Structural
Support
Vertical
Centertine
Lag Screws
5/16"x9x1-5/8"
-Door Spring
HARDWARE SHOWN ACTUAL SiZE
11JlllJll
Lag Screw
5/16"-9xl-5/8"
/
/
/
i
Highest Point of
Garage Door Travet
Garage
-- Door --
Vertical
Centediee
CEILING HEADER BRACKET INSTALLATION
• Extend the vertical centerline onto the ceiling as
shown.
• Center the bracket on the vertical mark, no more
than 6" (15 cm) from the wall. Make sure the arrow
is pointing away from the wall. The bracket can be
mounted flush against the ceiling when clearance
is minimal.
• Mark the side holes. Drill 3/16" pilot holes and
fasten bracket securely to a structural support with
the hardware provided.
Ceiting Mounting Holes
/
Header /
Bracket
6" (15 cm) Maximum
Door
Spring
Garage Do0r
- Finished Ceiling -
Vertical CenterIine
/ Lag Screws
5/16"x9x1-5/8"
-- Header Walt --
Centerline
14