Sectional Door And One-Piece Door With Track - Craftsman 139.53989 Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INSTALLATION
STEP
1
Determine
the
Header
Bracket
Location
To prevent possible SERIOUSINJURYor DEATH:
• Header bracket MUST be RIGIDLYfastenedto
structural support on header wall or ceiling, otherwise
garage door might not reverse when required DO NOT
install header bracket over drywall
• Concrete anchors MUST be used if mounting header
bracket or 2x4 into masonry
• NEVERtry to loosen, move or adjust garage door,
springs, cables, pulleys, brackets, or their hardware, all
of which are under EXTREMEtension
• ALWAYScall a trained door systems technician if
garage door binds, sticks, or is out of balance An
unbalancedgarage door might not reverse when
required.
Vertical
Centedine
Finished
Ceiling
2x4
StructuraI
Supports
/
Installation procedures vary according to garage door
types. Follow the instructions which apply to your
door.
SECTIONAL
DOOR AND ONE-PIECE DOOR
WITH TRACK
1. Close the door and mark the inside vertical
centerline of the garage door.
2. Extend the line onto the header wall above the
door.
You can fasten the header bracket within 4 feet
(1.22 m) of the left or right of the door center
only if a torsion
spring
or center bearing
plate
is in the way; or you can attach it to the ceiling
(see page 14) when clearance
is minimal.
(It
may be mounted
on the wall upside down if
necessary,
to gain approximately
1/2" (1 cm).
If you need to install the header bracket on a 2x4
(on wall or ceiling), use lag screws (not provided)
to securely fasten the 2x4 to structural supports as
shown here and on page 13.
3. Open your door to the highest point of travel as
shown. Draw an intersecting horizontal line on the
header wall 2" (5 cm) above the high point. This
height will provide travel clearance for the top edge
of the door.
NOTE: Door clearance brackets are available for
sectional doors when headroom clearance is less
than 2" (5 cm). See accessory page 39.
Proceed
to Step 2, page 14.
Ceiling
I
Header Walt
,,
2" (5 cm)
Track
Door
Sectional door
with curved track
One-piece
door
with horizontal
track
_all
Track
efTro etl I
go
5
12

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido