AMAZON COMMERCIAL B083V7GRH5 Manual Del Usuario página 17

Resistance measurement
• Insert the black connector lead (M) into the negative COM
(black) terminal (G) and the red connector lead (M) into the
positive V (red) terminal (L).
• Set the function switch (I) to the
• Press the MODE button (E) to shift to measuring the
resistance
the rest of the circuit does not interfere with the resistance
reading.
• Connect the test probes (M) across the circuit or component
being measured.
• If OL appears on the display (D), no current flow can be
measured due to open circuit or the resistance being too
high to measure.
• The stabilized value on the display (D) is read as the actual
reading.
Continuity measurement
• Insert the black connector lead (M) into the negative COM
(black) terminal (G) and the red connector lead (M) into the
positive V (red) terminal (L).
• Set the function switch (I) to the
• Press the MODE button (E) to shift to measuring the
continuity
display (D).
• Connect the test probes (M) across the circuit or component
being measured.
(Ohm). Disconnect one side of the product so
. The continuity indicator (6) lights up on the
position.
position.
EN
17