Detergent Suction; Control Components - Renson 160991 Manual Del Usuario

EN
regulations stated above, the manufacturer
declines all responsibility for the staff and
provides no warranty.
FILLING UP WITH FUEL
Fill the tank with the fuel indicated on the tech-
nical data plate (Diesel, ref. 1, pos. 14).
Avoid that the tank is empty when the machine is
running in order not to damage the fuel pump.
•
Incorrect fuel shall not used as they as
provide hazard.
Fill up the detergent tank with the suggested
products, suitable for the kind of washing to be
carried out (ref. 1, pos. 13).
•
CAUTION: Make use only of liquid de-
tergent, do not absolutely use acid or
too much alkaline products. We suggest
you to make use of our products, which
have been studied for the use with washer
machines.
START-UP
Switch on the machine by pressing the switch
(ref. 1, pos.1) and leave it to run for a few min-
utes to eliminate any dirt and air bubbles from
the water circuit, then switch it off, connect the
high pressure line to the spray gun (ref. 3) and
fit the spray rod (ref. 4). Make sure that the de-
tergent regulator is in the closed position.
When the machine is running again, check that
the jet is even; otherwise, clean the nozzle to
remove any dirt. Wait a few seconds for the op-
erating pressure to be reached, then operate
the gun for two or three short bursts.
To wash with hot water, press the switch (ref. 1,
pos. 4) and turn the thermostat (ref. 1, pos. 2) to
the desired temperature setting. To mix deter-
gent or disinfectant to the water jet, adjust the
quantity on the detergent pump or the control
cock (if any).
> LANCE ASSEMBLY
To fit the lance to the gun, it is sufficient to in-
sert the threaded end of the lance (ref. 4, pos.
1) into the hole on the gun (ref. 4, pos. 2); then
24
screw the lance as shown by the arrow (A) until
the connection is tight.
>

DETERGENT SUCTION

The detergent is automatically aspirated when
you press the detergent switch (fig. 1, pos. 5).
•
CAUTION: Make use only of liquid de-
tergent, do not absolutely use acid or
too much alkaline products. We suggest
you to make use of our products, which
have been studied for the use with washer
machines.
>

CONTROL COMPONENTS

4
5
CONTROL SWITCHES
1
Motor pump switch
2
Burner switch
3
Detergent switch
4 Internal switch
5
Water temperature controller
6
Pilot lights
- position ON: enables the external con-
4
trols
- position OFF: disables the external con-
1
2
3
A B C
6