Notes; Receiving The Product; Inspecting The Product; Scope Of Delivery - Grundfos JP Serie Instrucciones De Instalación Y Funcionamiento

CAUTION
Indicates a hazardous situation which, if not avoided,
could result in minor or moderate personal injury.
The hazard statements are structured in the following way:
SIGNAL WORD
Description of the hazard
Consequence of ignoring the warning
• Action to avoid the hazard.

2.3 Notes

The symbols and notes below may appear in Grundfos installation
and operating instructions, safety instructions and service
instructions.
FM
Observe these instructions for explosion-proof products.
A blue or gray circle with a white graphical symbol
indicates that an action must be taken.
A red or gray circle with a diagonal bar, possibly with a
black graphical symbol, indicates that an action must not
be taken or must be stopped.
If these instructions are not observed, it may result in
malfunction or damage to the equipment.
Tips and advice that make the work easier.

3. Receiving the product

3.1 Inspecting the product

On receipt of the product, do the following:
1. Check that the product is as ordered.
If the product is not as ordered, contact the supplier.
2. Make sure that the supply voltage and frequency correspond to
the values stated on the product nameplate.
Related information
6.3.1 Nameplate example for JP PS

3.2 Scope of delivery

The box contains the following items:
• 1 Grundfos JP PS pump
• 1 Quick Guide
• 1 Installation and Operating Instructions booklet.

4. Installing the product

4.1 Location

The product can be installed both indoors and outdoors.
Please observe the following:
• Install the product to enable easy inspection, maintenance, and
service.
• We recommend that you place the product as close as possible
to the liquid to be pumped.
• We recommend that you install the product near a drain or in a
drip tray connected to a drain in order to lead away possible
condensation from cold surfaces.
Related information
4.1.3 Ambient temperature during operation
4.1.1 Minimum space
Ensure sufficient space for service and maintenance, and for motor
cooling.
• We recommend a clearance of 20 inches (0.5 m) on three
sides of the product which should include the rear for cooling of
the motor.
• The motor is fan-cooled, so do not block the fan cover.
• If you install the product with one side against a wall, make
sure that the nameplate is visible.
4.1.2 Installation of the product in a frosty environment
Protect the product from freezing if it is to be installed outdoors
where frost may occur.
4.1.3 Ambient temperature during operation
The ambient temperature range for continuous operation
(S1 mode) is up to 104 °F (40 °C).
The ambient temperature range for intermittent operation
(S3 mode) is 104 to 131 °F (40 to 55 °C).
During intermittent operation (S3 mode), the product shuts off
periodically to avoid overheating.
Ambient temperature, continuous operation (S1 mode)
Up to 104 °F
The pump can run continuous operation. For
intermittent operation, see the table below.
(40 °C)
Ambient temperature, intermittent operation (S3 mode)
The overheating protection ensures that the pump
runs intermittent operation when the air temperature
104-131 °F is too high to cool the motor efficiently.
(40-55 °C) Example of intermittent cycle: the pump runs for 20
minutes and stops for 40 minutes before it starts
again.
Related information
4.1 Location
10.1 Operating conditions
5